MPE/iX Commands Reference Manual (32650-90877)

602 Chapter14
Command List XII
Commands STREAM thru XEQ
number ( xxx ), the percentage of file space used ( yy ), and the current open log file ( zzz ), as
shown in the following example:
SYSTEM LOG FILE # xxx IS yy % FULL
SYSTEM LOG FILE # zzz IS ON
If this command is issued and logging is not active the following message is displayed:
NO LOGGING
LOG FILE xxx IS y y% FULL
NOTE Do not create new log files with the BUILD command since MPE/iX creates
them automatically. If you use the BUILD command to create a new log file
and then attempt to switch the current log file to the file you created, user
logging suspends in an error state and the following message is displayed:
SYSTEM LOG FILE # xxx ENCOUNTERED ERROR # nnn
LOGGING SUSPENDED.
Use
This command may be issued from a session, job, program, or in BREAK. Pressing
Break
has no effect on this command. System supervisor (OP) capability is required to use this
command.
Example
To switch logging to a new log file, enter:
SWITCHLOG
Related Information
Commands CHANGELOG, RESUMELOG, SWITCHNMLOG
Manuals
SPU Switchover/XL User's Guide
System Startup, Configuration, and Shutdown Reference Manual
SYSGEN
Starts configuration dialog and/or installation tape creation. The equivalent compatibility
mode command is SYSDUMP. (Native Mode)
Syntax
SYSGEN[
basegroup ] [, newgroup ] [, inputfile ] [, outputfile ]
Parameters
basegroup The name of a base configuration group in the SYS account which contains
configuration data to be used as a basis for any changes made during the
SYSGEN session and/or to be used for creation of the installation tape. If
the name of a base group is not specified in the SYSGEN command, it
defaults to the group used to bring up the system (normally CONFIG). The