MPE/iX Commands Reference Manual (32650-90877)

420 Chapter11
Command List IX
Commands RECALL/=RECALL thru RUN
This file may consist of fileset(s) and option(s) , but only options can
appear after the first semicolon (:) on each line. An option specified on one
line will operate on all files in the
filesetlist .
^
indirectfile is the preferred format. If you use ! indirectfile , the CI
will interpret this as a variable reference, so you will have to specify
indirectfile instead.
fileset Specifies a set of files to be restored, and optionally those files to be
excluded from the RESTORE operation. The
fileset parameter has the
form:
filestorestore [- filestoexclude [..]]
The system restores any file that matches filestorestore unless the file
also matches
filestoexclude , which specifies files to be excluded from
the RESTORE operation. You may specify an unlimited number of
filestoexclude .
Since "-" is a valid character for HFS syntax file names, a blank character
must separate it from HFS file sets to obtain the special negative file set
meaning.
filestorestore
filestoexclude
Both filestorestore and filestoexclude may be entered in MPE or
HFS syntax. Wildcards are permitted for both MPE and HFS syntax.
The MPE syntax is as follows:
filename [. groupname [. accountname ]]
A lockword may be specified for files to be restored, in the form:
filename/lockword.group.account
The HFS syntax is as follows:
/dir_lev_1/dir_lev_2/.../dir_lev_i/.../filedesig
or
./dir_lev_i/dir_lev_j/.../dir_lev_k/.../filedesig
If the name begins with a dot (.), then it is fully qualified by replacing the
dot with the current working directory (CWD).
Each of the components
dir_lev_i and filedesig can have a maximum
of 255 characters with the full path name being restricted to 1023
characters. Each of the components
dir_lev_i and filedesig can use the
following characters:
Letters a to z
Letters A to Z
Digits 0 to 9
Special characters - _ .
For HFS syntax, the lowercase letters are treated distinctly from the