Legato NetWorker ClientPak and Storage Node Installation Guide

32
Configuring the Storage Node on the NetWorker Server
3
To configure the DLT Library on an HP 3000 perform the following steps:
1. During bootup, run ODE at the ISL prompt:
ISL>
ODE
Note that the MPE ISL ODE “RUN MAPPER” utility might not recognize and list
all fast-wide SCSI devices.
2. Run mapper to get device paths:
ODE>
RUN MAPPER
STARTING EXECUTION OF MAPPER
Processer Identification:
...
I/O Configuration:
Type HW SW Revisions
Path Component Name ID Mod Mod Hdwr Firm
...
/4/4 HP-PB Fast Wide SCSI . . .
/4/4.0.0 C1194F . . .
/4/4.1.0 DLT7000 . . .
/4/4.2.0 DLT7000 . . .
/4/4.3.0 DLT7000 . . .
/4/4.4.0 DLT7000 . . .
3. Boot the system.
At the MPE prompt, run sysgen and start the io section:
:
sysgen
SYSGEN version E . . .
sysgen>
io
** IO configurator commands **
4. If not already configured, configure the differential card and the pseudo/target
level of the SCSI path:
io>
apath 10/4/4 id=HP28696A
io> apath 10/4/4.0 id=pseudo
io> apath 10/4/4.1 id=pseudo
io> apath 10/4/4.2 id=pseudo
io> apath 10/4/4.3 id=pseudo
io> apath 10/4/4.4 id=pseudo