Installing and Managing HP ARPA File Transfer Protocol Network Manager's Guide (36957-90157)

Appendix A 75
Error Messages
FTP User Messages and Errors
ACTION: Enter the USER command to logon, or the CLOSE command
before opening another connection.
MESSAGE: FTP Unknown Error Detected. Subsystem = !,
Information = ! (FTPERR 28)
FTPERR 28 CAUSE: An unknown error was detected from some underlying
subsystem.
ACTION: Seek the assistance of your Hewlett-Packard representative
for assistance.
MESSAGE: (We only support MPEXL Fixed and Variable record
format, sorry. FTPERR 29)
FTPERR 29 CAUSE: The user specified a BUILD command parameter for record type
that was not Fixed or Variable.
ACTION: Only fixed and variable record format is supported. Refer to
the HP ARPA File Transfer Protocol User’s Guide for assistance.
MESSAGE: We only support MPEXL Standard files, sorry.
(FTPERR 30)
FTPERR 30 CAUSE: The user specified a build parameter for a file type that is not of
type Standard (STD).
ACTION: Only the STD file type is supported. Refer to the HP ARPA
File Transfer Protocol User’s Guide for assistance.
MESSAGE: We don’t allow MPEXL file equates, sorry. (FTPERR 31)
FTPERR 31 CAUSE: The user attempted to use a file equate during a file transfer.
ACTION: File equates are not yet supported. Try the transfer again
without using file equates.
MESSAGE: Remote server receive timeout. Closing connection.
(FTPERR 32)
FTPERR 32 CAUSE: The FTP user did not receive a required reply from an FTP
server in the allocated time window.
ACTION: Close the connection and quit before trying again. Try to ping
the remote system using PING.NET.SYS. If this does not succeed, no
FTP connection can be established. Follow the troubleshooting
instructions in the Installing and Managing HP ARPA File Transfer
Protocol Network Manager’s Guide.
MESSAGE: ExitOnError mode on. (FTPERR 33)
FTPERR 33 CAUSE: The EXITONERROR command was entered while the
exit-on-error feature was disabled.
ACTION: None.