HP System Dictionary/XL General Reference Manual Vol 2 - Part 1 SDINIT (32256-90005)

7- 41
5 SDCONV Commands
Overview
This chapter includes descriptions of all SDCONV commands with their syntax and parameters.
A HELP command is provided for a quick reference to SDCONV commands. Using this command, you can
get either a list of all available commands, or a detailed description of a particular command.
NOTE Throughout this section, the Dictionary/V dictionary may also be referred to as "the
dictionary", while HP System Dictionary/V is referred to as "System Dictionary".
SYSDIC Command
The SYSDIC command is used to open System Dictionary, and has the following format:
SYSDIC parameter-1meter-2;...meter-n.
The ending period signals completion of the command, and the sequence of the parameters has no
significance at all. Upon receiving this command, SDCONV opens System Dictionary as specified. The
parameters accepted by the SYSDIC command are described below.
NAME Parameter
This parameter specifies the particular System Dictionary to open, and has the following format:
NAME = <System Dictionary name>
The default value is SYSDIC.
SCOPE Parameter
This parameter specifies the scope used to open System Dictionary, and has the following format:
SCOPE = <scope name>
There is no default value for this parameter. You will get an error if you attempt to open System
Dictionary without a scope name.
PASSWORD Parameter
This parameter specifies the scope password used to open the dictionary, and has the format:
PASSWORD = <password>
There is no default for this parameter. If you omit this parameter when the scope is specified, you will be
prompted for it.
DOMAIN Parameter
This parameter is used to specify the System Dictionary domain, and has the format:
DOMAIN = <domain name>
If you leave the value of this parameter blank ("DOMAIN="), then the common domain will be opened.
The common domain is represented by a blank entry in the SHOW display also. The default value for this
parameter is the common domain.