HP System Dictionary/XL General Reference Manual Vol 2 - Part 1 SDINIT (32256-90005)

2- 17
Volume 1. The echo is turned off for entry of the password.
__________________________________________________
| |
| External name of version in common domain >|
| Internal name of version in common domain >|
| External name of DA scope > |
| Internal name of DA scope > |
| Password for DA scope > |
| Verification of DA password > |
__________________________________________________
If you enter [[RETURN]] or do not type in the same password at the Verification of DA password> prompt,
the following message will appear and you will again be prompted for the password and verification:
Verification of password failed (SDERR 2205)
Once you have supplied names in response to the above prompts, S DINIT will list the names which you
have entered (indicated here by xxx's), thus allowing you to verify them:
_______________________________________________________
| |
| External name of version in common domain is xxx|
| Internal name of version in common domain is xxx|
| External name of DA scope is xxx |
| Internal name of DA scope is xxx |
| Are the names correct? (Y/N) > |
_______________________________________________________
If you answer "N" to Are the names correct? (Y/N) >, you will then be reprompted starting with
External name of version in common domain >.
If you answer "Y" , and SDTEMP1 exists, you will be prompted for permission to overwrite it, as shown
below.
SDTEMP1.groupname.accountname already exists. Is it okay to overwrite (N/Y)?
If you answer "N" to this prompt, SDINIT will terminate.
Submitting the Job Stream
You have now completed the process of supplying the necessary initialization information and the only step
that now remains to be done is to submit the job stream which completes the initialization process. If your
response was "Y" to the prompt Are the names correct? (Y/N) >, you should now see the following prompt:
Input Priority of Job Stream (8) >
Here, you specify the input priority for the job. If [[RETURN]] is entered, the default value of 8 which is
shown in the prompt will be used. Otherwise, you can enter any priority from 1 (the lowest priority) to 13
(the highest priority). You can, therefore, defer the execution of the job if necessary.
You must now specify an output priority for the job stream listing:
Output Priority for Job Stream Listing (8) >
As with the input priority, the default for the output priority is also 8 and will be used if [[RETURN]] is