HP SNMP/XL User's Guide (36922-90036)

36 Chapter3
Using SNMPUTIL
SNMPCONTROL User Defined Command
the name of the trace file instead of using the default
trace file name as the value of
file_name . File_name
must be a string of characters that define a valid MPE
file name.
TFILE-SIZE=file_size
This parameter is optional and is ignored unless the
TRACE parameter is specified. It allows you to specify
the number of records in the SNMP/XL trace file as the
value of
file_size . The value should be a decimal
number specifying the trace file size in number of 128
word records.
The default is 1024.
Description
This command controls the HP SNMP/XL internal trace facility. When
tracing is enabled the default trace file, created by the Node
Management Subsystem, is named NMTCnnnn.PUB.SYS, where nnnn
reflects numerically sequential trace files. If the
TFILE parameter is
specified, then the
file_name specified is the name of the trace file.
Example
One of the examples below (SNMPINFO 1724) starts the internal trace
facility, specifying the number of trace records at 2048.
MPEXL: snmpcontrol trace;on; TFILESIZE=2048
The SNMP/XL subsystem trace facility has been successfully activated
on trace file. (SNMPINFO 1724)
Tracing stopped on file. (SNMPINFO 1726)
MPEXL:
SNMPCONTROL UPDATECONFIG
The SNMPCONTROL UPDATECONFIG command allows you to dynamically
update the configuration information.
SNMPCONTROL UPDATECONFIG
Parameters
None.
Description
This command provides the ability to update the SNMP configuration
information without shutting down the HP SNMP/XL subsystem. The
configuration information that is updated is contained in the
SNMPCONF.NET.SYS file.