HP SNMP/XL User's Guide (36922-90036)

Chapter 3 35
Using SNMPUTIL
SNMPCONTROL User Defined Command
SNMPCONTROL STOP
The SNMPCONTROL STOP command allows you to shut down the
SNMP/XL subsystem. Use of this command gracefully terminates the
SNMP/XL subsystem.
SNMPCONTROL STOP
Parameters
None.
Description
This command gracefully terminates the HP SNMP/XL subsystem.
Example
MPEXL: snmpcontrol stop
The stop request has been successfully sent to the SNMP/XL stack.
(SNMPINFO 1702)
MPEXL:
SNMPCONTROL TRACE
The SNMPCONTROL TRACE command allows you to enable or disable the
internal trace facility of the SNMP/XL subsystem.
SNMPCONTROL TRACE
[;ON|OFF]
[;TFILE=file_name]
[TFILESIZE=file_size]
Parameters
ON/OFF
This parameter is optional. If it is not present, the
current state of the internal trace is toggled. For
example, if tracing is enabled, the internal trace is
disabled if the parameter is not present.
The
ON parameter enables the internal trace facility. If
tracing is currently active, the current trace file is
closed.
The
OFF parameter disables the internal trace facility.
If tracing is currently not active, then the command is
ignored.
TFILE=file_name
This parameter is optional and is ignored unless the
TRACE parameter is specified. It allows you to specify