HP e3000/iX Network Planning and Configuration Guide (36922-90037)

210 AppendixB

NS X.25 Migration: NS 3000/XL Releases 1.0, 1.1, or 1.2 to NS 3000/iX Release 2.0 or Later

To Convert NS 3000/XL 1.X to 2.0 Files

The following procedure describes the steps necessary for conversion.

Step 1. At the MPE/iX prompt, type:

Run NMMGRVER.PUB.SYS

Step 2. At the prompt, enter the ﬁlenames to convert:

Fileset to be scanned?

For example, enter NMCONFIG.PUB.SYS, then press

[RETURN]. You can

enter one ﬁle name or a set of ﬁles in the following form:

filename [.groupname [.acctname]]

@ [.groupname [.acctname]]

@.@ [.acctname]

@.@.@

Step 3. NMMGRVER creates a backup of the ﬁle and displays the following

message:

OK to convert filename.groupname.acctname?_

The backup ﬁles are named NMBACKA, NMBACKB, and so on. To proceed,

enter Y for Yes, then press

[RETURN]. Press [RETURN] or type N,

[RETURN] to exit.

Step 4. NMMGRVER displays the following message:

Backup file is NMBACKY, temporary file is Nnnnn.

Step 5. The ﬁle conversion proceeds without further input. When complete, the

message:

CONVERSION COMPLETED SUCCESSFULLY

is displayed.

Step 6.

Rename the converted ﬁle if required. Make any updates to the DTS

subystem using NMMGR as required for your installation to complete

the conversion. For full details, refer to Conﬁguring Systems for

Terminals, Printers, and Other Serial Devices if your system uses

PC-based network management, or to Conﬁguring and Managing

Host-Based X.25 Links if your system uses host-based network

management.