HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 13 183
Configuring Logging
To Modify the Logging Configuration
Disk Logging The value entered in this field specifies whether or not
logging events for the subsystem and class listed beside
the field will be logged to a disk file. A value must be
entered for each subsystem and class listed. A Y (yes)
enables logging to a file, N (no) disables logging to a file.
The file name for the log file is NMLGnnnn.PUB.SYS,
where nnnn is a number from 0000 to 9999. All logging
classes in all subsystems are logged to this file. At each
system startup, or when a file is full, the node
management services subsystem (NMS) creates a new
NMLGnnnn.PUB.SYS file, naming each successive
logging file by incrementing nnnn. When
NMLG9999.PUB.SYS is full, NMS names the next
logging file NMLG0000.PUB.SYS.
The Netxport Log Configuration (2) screen (#60) in Figure 13-3 is
displayed when you press the
[Next Screen] function key from the
Netxport Log Configuration (1) screen (#61) in Figure 13-2.
Figure 13-3 Netxport Log Configuration (2) Screen
Use the fields and the function keys of the screen to configure logging
for the subsystems represented on the screen. If the subsystem for
which you want to enable logging does not appear on this screen, press
the
[Next Screen] function key to go to the next Netxport Log
Configuration screen. There are a total of six logging configuration
screens.