HP e3000/iX Network Planning and Configuration Guide (36922-90037)

162 Chapter11
Configuring the Network Directory
To Open the Network Directory
To Open the Network Directory
The Open Configuration/Directory file screen (#1) in Figure 11-2 is the
first screen displayed when you run NMMGR.
Figure 11-2 Open Configuration/Directory File
Step 1. Verify that the correct network directory file name is in the Network
directory file name field.
Step 2. If you have assigned a write access password, enter it in this field. If
you are not using the password feature, leave this field blank.
Step 3. Press the
[Open Directry] key. If you are creating the file for the first
time, NMMGR will ask you to verify creation. Press the
[Open Directry]
key again to continue.
Fields Configuration
file name The only configuration file name the system recognizes
for use by the network subsystem is
NMCONFIG.PUB.SYS. You can, however, create or
modify a configuration file using a different name and
save it as an offline configuration file. You can use
offline configuration files as a means of creating and
storing configurations that you want to use in the
future or that you are preparing for use on a different
system. When you are ready to use an offline