HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 8 149
Configuring an X.25 Node
To Configure Neighbor Gateways
Figure 8-5 Neighbor Gateway Reachable Networks Screen
Step 1. In the Neighbor Gateway IP Internet Address field, enter the IP
address of the gateway specified on the Neighbor Gateways screen. An
example is: C 192.007.007 001
Step 2. In the IP Network Address fields under the title Configured
Reachable Networks, enter the IP addresses of all the remote
networks that can be reached through the gateway whose IP address is
configured in the previous field.
Step 3. The IP subnet mask is optional. If entering one, tab to the next field. In
the IP mask field, enter the number in the same format as an IP
address.
Step 4. In the field labeled Hops, enter the number of hops (full gateways)
needed to get to the target network. Two partner gateway halves count
as one hop.
Step 5. Repeat steps 2, 3, and 4 for each remote reachable network. The
information configured in this screen can extend to more than one page,
if necessary, to allow configuration of up to 2550 reachable networks per
link (255 pages and 10 reachable nets per page). If you need to
configure more than 10 networks, press the
[Save Data] key then press
the
[Next Page] key to enter more networks.
Step 6. After you have finished entering the IP addresses of all the reachable
networks, press the
[Save Data] key. Press the [Prior Screen] key to
return to the Neighbor Gateways screen.