HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix A 201

Manually Installed Products

Conﬁguring File Transfer Protocol (FTP)

To conﬁgure FTP so it is enabled after the update or install of MPE/iX 6.5:

1. Remove any passwords from MANAGER.SYS.

2. Stream FTPCNFJ.ARPA.SYS.

:STREAM FTPCNFJ.ARPA.SYS.

This will add FTP entries to the appropriate Internet Super Daemon ﬁles.

For more information on the speciﬁcs of these entries, refer to the Installing and

Managing HP ARPA File Transfer Protocol Network Manager’s Guide, in the chapter

“Starting FTP”.

3. Reset any passwords on MANAGER.SYS that Step 1 removed.