HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

132 Chapter5
Modifying Your System
5.11 Securing the System
nn the numeric release number (for example, OSA10.TELESUP and
0SB23.TELESUP).
Go to Step 17.
17.Rename the COMMAND.PUB.SYS file, except checklists L and M which included this step
in section 5.7
:RENAME COMMAND.PUB.SYS,command_name
where command_name is a temporary name you are assigning the file. This preserves
your UDC information for later use. Record the temporary name on your checklist.
18.If you are performing a Remote system task or CD-ROM task, go to Step 19.
If you are performing an Add-on, Manage Patch, or Staging Area task with tape or
disk on a local system, go to Step 20.
Remote Tasks CD-ROM Tasks
19.If you are preparing a CSLT tape on a central system for distribution to a remote
system or if you are modifying the remote system:
a. Purge the HPINSTFL file.
:PURGE HPINSTFL.INSTALL.SYS
It removes old audit trails, if they exist.
CAUTION Do not purge HPINSTFL if you are updating the local system (the system your
are currently logged on to). Also do not purge the HPINSTFL if you are
installing additional SUBSYS products.
b. Go to Step 20.
20.If you are performing a PowerPatch task, go to Step 21.
If you are not performing a PowerPatch task, go to the next section on your checklist.
PowerPatch Tasks
21.Restore the AUTOINST file set and its dependencies, except for checklists L and M which
included this step in section 5.7.
a. Log onto the INSTALL group, and enter the following at the system prompt:
:HELLO MANAGER.SYS,INSTALL;HIPRI
:FILE PPT;DEV=TAPE
b. Mount the PowerPatch tape and put the tape drive online. Issue the following
command to restore the files:
:RUN STORE.PUB.SYS;INFO="RESTORE *PPT;A@,F@;SHOW;DEV=1"
c. Dismount the tape when the restore is complete.
• Securing the System completed. Go to the next section on your checklist.