HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Chapter 2 49
Task Checklists
Checklist M. Using AUTOINST to Add-on and Apply PowerPatch
Checklist M. Using AUTOINST to Add-on and Apply
PowerPatch
Use this task checklist if your source material is on tape and you are using AUTOINST with
a CSLT tape to:
• Add-on purchased products and apply PowerPatch patches
Patch/iX is the recommended method for installing patches because Patch/iX will qualify
patches for you. This checklist is provided only for experienced system installers who elect
to use AUTOINST to install PowerPatches.
Print a copy of this checklist for each system that you are applying add-on products to.
Read and perform the steps only in the following sections:
Begin Preparation Tasks.
Does not require exclusive access to the system.
Chapter 3 , “Planning for Your Task.”
— 3.1 Verifying Required Materials
— 3.2 General Planning Tasks
— 3.4 Checking Tape Media
— 3.6 Estimating Disk Space
Record contiguous disk space:
Record non-contiguous disk space:
Chapter 4 , “Preparing Your System.”
— 4.1 Reserving Disk Space for Tape Tasks
Preparation Tasks completed.
Schedule downtime for exclusive access.
Begin Exclusive Access Tasks.
Chapter 5 , “Modifying Your System.”
— 5.7 Creating CSLT using AUTOINST—
Select Option 2, “SUBSYS (Add-On) and
PowerPatch.”
— 5.11 Securing the System
Record terminated logging processes:
Record temporary filename for the COMMAND.PUB.SYS file:
— 5.13 Applying the CSLT Modification
— 5.14 Restarting the System
— 5.15 Rerunning AUTOINST
Chapter 6 , “Finishing the Process.”
— 6.1 Configuring Datacomm and UPS