HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix H 417
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
1015 Message Output from SORT/iX failed. SORT status: Subsys:
value
, Info:
value
(STAGEMAN 1015)
Cause STAGEMAN received an error from the
HPSORTOUTPUT intrinsic of the SORT/iX subsystem.
Action Determine why the HPSORTOUTPUT intrinsic failed.
Contact your Hewlett-Packard Response Center for
assistance.
1016 Message No staging areas exist. (STAGEMAN 1016)
Cause No staging areas were found in the HP Stage/iX
environment.
Action None if this is an expected event. If one or more staging
areas should exist, then a RECOVER command may be
necessary (do a HELP on RECOVER for more
information).
1017 Message The staging area does not exist or no match
found. (STAGEMAN 1017)
Cause The staging area given for the LIST command was not
found in the HP Stage/iX environment. If a wildcard was
used for the staging area parameter, then no matches for
that pattern were found.
Action Check the spelling on the staging area parameter
(remember that staging area names are case-sensitive).
1018 Message No staging area contents file found in the IMPORT
directory. (STAGEMAN 1018)
Cause An IMPORT command was done, but the HP Stage/iX
Import directory (/SYS/hpstage/import/) did not contain a
“contents” file needed for constructing the staging area to
be imported (the contents file is called “stage_contents”).
This most likely means that the staging area being
imported was not moved correctly into the Import
directory, or that the Import directory is empty.
Action Re-IMPORT the staging area using the appropriate
import option (e.g., ;TAPE). If you are moving a staging
area into the Import directory using your own transport
method (and therefore importing with the ;NOUNPACK
option), make sure the contents file for the staging area is
moved in with the other files.
1019 Message Can't open the Import Staging Area contents
file. (STAGEMAN 1019)
Cause STAGEMAN encountered a file system error while trying
to open the contents file for the staging area to be
imported (the contents file name is
“/SYS/hpstage/import/stage_contents”)