HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
408 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
BASE-VERSION. You cannot continue with
installation (INSTERR #255)
Cause The system OS version is newer than the CS OS version.
HPINSTAL allows CSLT creation under this condition
only for remote systems.
Action Use HPINSTAL to create CSLT for local systems with only
newer versions OS CDs.
256 Message HPCIGETVAR failed in create CSLT (INSTERR #256)
Cause The installer issued the HPCIGETVAR intrinsic and
failed. The status returned for this message is displayed
before this message.
Action Check the error message from the HPCIGETVAR intrinsic
and based on the status value displayed, take corrective
action.
• Run the installer again.
• Contact Response Center if further assistance is
required.