HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

402 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
• VSCLOSE both CD-ROM volumes and follow the setup
procedures in the HPINSTAL manual. Run HPINSTAL
from the start.
• Save all messages on the screen and check the
messages in the bottom of AUTOLOG. Call the
Response Center for further assistance.
224 Message Error reading from terminal with READX (INSTERR
#224)
Cause A physical I/O error occurred.
Action Logon again, make sure the first CD-ROM volume is
mounted and restart HPINSTAL.
225 Message Failed to reset file equations for filename.
(INSTERR #225)
Cause An attempt to reset the file equation for filename using the
HPCICOMMAND intrinsic failed.
Action Document all the messages received prior to the error and
report the problem to the Response Center for assistance.
Message 226-229 Not used
230 Message Incorrect password provided for Current IFILE
indicated
in HPINSTFL. (INSTERR #230)
Cause You entered incorrect passwords for an I-file when MPE
prompted for the passwords. This caused the Installer to
fail.
Action • Restart the Installer. The failed I-file will be
restreamed.
• Contact the Response Center if further assistance is
required.
231 Message Embedded passwords are not allowed due to
password security.
The Installer cannot continue. (INSTERR #231)
Cause Embedded passwords are not allowed with the Security
Monitor/iX product. The Installer cannot stream the
I-files.
Action • Use the Security Monitor/iX configurator to disable this
feature.
• Restart the Installer.
Message 232-234 Not used
235 Message PowerPatch tape is older than the current system
powerpatch (INSTERR #235)