HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Appendix H 393
Error Messages and Warnings
Installer Error Messages (INSTERR)
• Contact the Response Center if further assistance is
required.
190 Message The installer encountered an error building the
file SYSGLOG.
(INSTERR #190)
Cause The installer was attempting to build the file SYSGLOG.
Action • Document any error message text prior to the error.
• If old SYSGLOG exists, purge it.
• Check for enough free disk space to build files. There
are two methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
191 Message Error encountered while setting SYSGLOG file
equation. (INSTERR #191)
Cause The installer attempted to issue the file equation:
:FILE SYSGLOG;ACC=APPEND;MULTI
Action • Document any error message text prior to the error.
• FILE Command Table is possibly full.
• Do a LISTEQ command to determine which USER file
equations can be RESET.
• RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again. The installer will reissue any needed
file equations.
• Contact the Response Center if further assistance is
required.
192 Message Error encountered while purging the file
SYSPROGF. (INSTERR #192)
Cause The installer was attempting to purge the file SYSPROGF.
Action • Document any error message text prior to the error.