HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

378 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
space
on the System Volume set to stage the files for
building a customized
SLT. You do not have that space available. Please
consult the Error
messages section for alternatives to resolve
this problem. (INSTERR #134)
Cause The installer verifies it has enough disk space for the
creating the CSLT by building a 787,000 sector file. If the
build fails, the installer prints this message and
terminates.
Action • Ensure that there are 787,000 sectors of disk space for
running the installer. There are two methods for
obtaining additional disk space:
• Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation assignments
to 100% on all system volumes except LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
— Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
# Message The file filename from the POWERPATCH tape was
not successfully
processed. To continue with the installation,
consult the customer installation
procedures. (INSTER #135)
Cause The installer failed to decrypt a file from the
POWERPATCH tape.
Action • Check for tape errors, clean tape heads, etc.
• Take appropriate corrective measures and run the
installer again.
• If the file still fails to decrypt, it must be corrupted on
the tape -- Call the Response Center for further
assistance.
136 Message Invalid patchtype for binary patch, patch type =
patchtype. (INSTERR #136)
Cause A Binary patch has been found with a patch type other
than BA or BI.
Action Save PATCHAUD.INSTALL.SYS and contact the