HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A

360 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
Cause The installer was attempting to purge an old work nl,
TEMPNL.INSTALL used when patching the OS SOM.
Action • Examine file TEMPNL.INSTALL.SYS for accessors.
• If accessors, free up file.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
72 Message Copy of NL.INSTALL to TEMPNL failed when
patching the OS
SOM. (INSTERR #72)
Cause The installer was attempting to copy NL.INSTALL to
TEMPNL.INSTALL in preparation for replacing the OS
SOM with a patched OS SOM.
Action • Examine file TEMPNL for accessors other than the
installer.
• If TEMPNL is being accessed, free up file, then purge
TEMPNL.
• Check for free disk space to copy file, and if needed free
up disk space. There are two methods for obtaining
additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
73 Message Purge of NL.INSTALL failed when patching the OS
SOM. (INSTERR #73)
Cause The installer was attempting to purge the NL in
preparation of rebuilding it while patching the OS SOM.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the
installer again.