HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

328 AppendixH
Error Messages and Warnings
SETUP Error Messages (SETERR)
21 Message You must execute SETUP.INSTUTIL prior to
executing SETINIT.
(SETERR #21)
Cause SETINIT uses a secondary CI script called OLDACCTS to
establish MPE release-dependent variables. This script is
built by SETUP.INSTUTIL, and is deleted by
SETUP.INSTUTIL upon normal termination. Therefore,
SETUP.INSTUTIL must be executed first, and it must fail
prior to SETINIT.
Action • Ensure that the CD containing the INSTUTIL.SYS
group is online.
• From MANAGER.SYS,INSTALL, execute
SETUP.INSTUTIL.
• If SETUP.INSTUTIL fails, execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.
22 Message Unable to set file equation for the file
HPINSTAL.INSTALL. SETUP
will terminate. Follow the instructions in your
installation manual
to continue. (SETERR #22)
Cause SETUP.INSTUTIL forces the file HPINSTAL.INSTALL
onto LDEV 1 by setting a file equation prior to copying the
file from compact disk. However, SETUP.INSTUTIL failed
when attempting to set the file equation.
Action • Do a LISTEQ to determine the file equations that have
been set.
• Reset the files for which you no longer need file
equations. (If no file equations are needed, do a RESET
@.)
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.
23 Message Unable to set file equation for the file
HICAT000.INSTALL. Setup
will terminate. Follow the instructions in your
installation manual
to continue. (SETERR #23)
Cause SETUP.INSTUTIL forces the file HICAT000.INSTALL
onto LDEV 1 by setting a file equations prior to copying
the file from compact disk. However, SETUP.INSTUTIL
failed when attempting to set the file equation.