HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
304 AppendixG
HP Stage/iX Reference
HP Stage/iX Commands
There is a file, STAGEDEF.PUB.SYS, that contains all of the default values for files that
make up HP software products. This file contains multiple SETDEFAULT commands. The
STAGEDEF file is implicitly executed whenever STAGEMAN is run.
The SETDEFAULT command can be abbreviated as SETD.
Expert Mode Command:
Syntax
SETDEFAULT [FILE=]
file_name
[;DISK={ NONE}]
{CONTIG}
{ LDEV1}
[;DISP={ IGNORE}]
{REPLACE}
{ ADD}
{ DELETE}
[;ONERR={IGNORE}]
{ WARN}
[;VAL={BASIC} ]
{EXISTENCE}
{CHECKSUM}
[;VALINFO="validation_info"]
[;LIFTYPE={NONE} ]
{BOOT}
{IPL}
{DATA}
{AUTOF}
[;OWNER="owner_name"]
[;FILEGROUP={LDEV1} ]
{SLT}
{OTHER}
Parameters
[FILE=]file_name (Required)
The fully qualified filename for the file which the subsequent defaults should be set.
[;DISK=disk_restrict] (Optional)
Values: CONTIG
(C), LDEV1 (1), NONE(N)
Default: NONE (see also SETDEFAULT)
CONTIG — Implies that the file must be on LDEV1 and that the file requires contiguous