HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

294 AppendixG
HP Stage/iX Reference
HP Stage/iX Commands
Manager (SM) or System Operator (OP) capability to execute this command.
Syntax
EXIT
Parameters
(none)
Example
To exit from STAGEMAN, enter:
STAGEMAN> EXIT
EXPERT
The EXPERT command is used to put STAGEMAN into expert mode. There are several
STAGEMAN commands that extend the basic STAGEMAN functionality which require you to be
in EXPERT mode. All expert mode commands require SM capability. The EXPERT command
itself requires SM capability to execute.
The following commands are allowed in expert mode only:
NOTE The STAGEMAN prompt will always indicate which mode STAGEMAN is currently
executing in. When STAGEMAN is in normal mode, the prompt is STAGEMAN>.
When STAGEMAN is in expert mode, the prompt is STAGEMAN$.
Syntax
EXPERT [[MODE=]{ ON}]
{OFF}
Parameters
[[MODE=]{ ON} (optional)
{OFF}
If the MODE parameter is not specified then the EXPERT command will simply display the
current mode for STAGEMAN. Otherwise the EXPERT command will explicitly set STAGEMAN
Table G-5. Expert Mode Commands
Command Description
STAGEFILE (SF) Put a file in a staging area.
DELETEFILE (DF) Delete a file from a staging area.
CHANGEFILE (CF) Change the attributes of a staged file.
SETDEFAULT (SETD) Set the default attributes for a particular file.
SHOWDEFAULT (SHOWD) Display the default attributes for a file.