HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

286 AppendixG
HP Stage/iX Reference
HP Stage/iX Commands
CHANGE (CH)
The CHANGE command will allow you to change various attributes of an HP Stage/iX
staging area. Specifically, CHANGE will allow you to change:
• The name of the staging area.
• The description of the staging area.
The CHANGE command can be abbreviated CH.
Syntax
CHANGE [STAGE=] stage_name [[;NAME=] new_name ]
[[;DESC=] quoted_string ]
Parameters
[STAGE=]stage_name (required)
The current name of the HP Stage/iX staging area. This must be a valid staging area name
for a pre-existing staging area. The staging area cannot be in use, or designated for use on
the next boot (see the SET command).
Staging area names are case sensitive. “STAGE1” is not equivalent to “stage1” or “Stage1”.
[;NAME=]new_name (optional)
If this parameter is omitted then the current name of the staging area will be unchanged.
Otherwise, this name will be used for the new name of the staging area.
This must be a valid HP Stage/iX staging area name and must be unique. The staging area
name can be up to 16 characters in length. The name must be a valid MPE/iX directory
name. For this reason, the name cannot contain a slash (/) character. It can contain letters
(upper or lower case), numbers, and the special characters underscore (_), dash (-), and
period (.).
Staging area names are case sensitive. “STAGE1” is not equivalent to “stage1” or “Stage1”.
[;DESC=]quoted_string (optional)
If this parameter is omitted then the current description for the staging area will be
unchanged. Otherwise, this description will replace the old description for the staging
area.
SHOWDEFAULT
(SHOWD)
SM Display the default attributes for a
particular file.
COMPLETE (COMP) SM Mark a staging area as complete.
EXPERT SM Put STAGEMAN in expert mode.
Table G-4. Expert Mode Commands
Required
Command
(Abbrev)
Capabilities Description