HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

254 AppendixE
CD-ROM Resources
Adding a CD-ROM Drive
( then add the devices; `.0' is appended to path
identifier )
io> ADEVICE LDEV=11 PATH=52.3.0 CLASS=DISC ID=HPA1999A
LMGR=LOGICAL_DEVICE_MANAGER PMGR=SCSI_DISC_DM
( then do the same for LDEV 12 )
io> ADEVICE LDEV=12 PATH=52.4.0 CLASS=DISC ID=HPA1999A
LMGR=LOGICAL_DEVICE_MANAGER PMGR=SCSI_DISC_DM
6. Hold the changes you just made, exit the IO configurator, keep the new configuration,
and exit SYSGEN:
io> HOLD
io> EXIT
sysgen> KEEP CONFIG
(Keep the changes to the current config group.
This assumes the group name is CONFIG.SYS.)
sysgen> EXIT
7. Shut down the computer system:
CTRL A
=SHUTDOWN
After you see the message SHUT 6, power off the computer.
8. Connect the CD-ROM drive to the card using the path you configured.
9. Set the voltage selector switch, if necessary, on the back of the CD-ROM drive. It should
be set correctly.
10.If installing a SCSI CD-ROM drive, be sure that the SCSI bus is terminated properly at
each end of the bus.
11.Power on the CD-ROM drive.
12.Power on the computer and boot the system from the primary path. The boot message
varies depending on the system model.
If you system asks you to enter the boot path, enter the primary boot path.
If your system asks “Boot from primary path?” respond Y.
Enter Y to Interact
with IPL (or ISL)? if it appears on your screen.
13.Verify the I/O configuration using ODE:
• If you are on a 5.0 or greater system:
ISL>ODE
ODE>RUN MAPPER
Refer to “5.3 Listing the System Configuration” in Chapter 5 , “Modifying Your
System,” for procedural information. Also refer to the Offline Diagnostics
Environment (ODE) User’s
Manual.
The system displays the I/O configuration for the system. You need to check whether
the CD-ROM drives have been configured correctly by seeing whether MPE/iX