HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix E 231
CD-ROM Resources
Loading and Mounting CD-ROM Disks
To dismount a CD-ROM disk from an HP-IB drive:
:VSCLOSE
volume_set_name
Checking Volume Set Status
To check on the status of the CD-ROM disks, you can use the DSTAT command. For
example:
: DSTAT
LDEV-TYPE STATUS VOLUME (VOLUME SET - GEN)
---------- -------- --------------------------
11- 017070 LONER HPINSTAL (MPE_C.55.00_1-0)
12- 017070 LONER HPINSTAL (MPE_C.55.00_2-0)
As shown in the example, the command output lists the logical device number and type,
the drive status, the volume name (the program name), and the volume set name. The two
disks in the example are not online because the status says LONER. When they are online,
the status reads MASTER-RO.