HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Appendix D 225
Backdating Your System
Finishing Up
SP>RS
If the system does not respond, press the reset button, key switch, or on/off switch as
appropriate for your system.
Enter Y to confirm restarting the system.
3. Boot the system from the primary boot path.
a. Boot messages can vary, depending on the system model.
b. Enter Y to the Interact with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
4. At the ISL prompt, enter:
ISL>START NORECOVERY
5. Confirm the date and time.
6. Log on.
:HELLO MANAGER.SYS;HIPRI
Restart System Functions
Refer to “Restarting Selected System Functions” in Chapter 6 , “Finishing the Process,” for
additional information about any of these steps.
1. On local systems power cycle the DTCs. On remote systems reset DTCs.
If you are using OpenView DTC Manager, the DTCs do not need to be power cycled.
To power cycle all DTCs:
a. Turn DTC off.
b. Turn DTC on.
Power cycling each DTC enables the new download file and the DTC configurations to
be downloaded to the DTC(s). To reset DTCs:
a. Type:
:SYSDIAG
DUI>TERMDSM
b. For each DTC, type:
DUI>RESET DTC nn
Where nn is the DTC number.
2. Purge groups.
:PURGEGROUP USL
:PURGEGROUP UXL
:PURGEGROUP UNL
3. Start data communications.
If you have NS 3000/iX configured, bring up the configured network interfaces. For