HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

206 AppendixD
Backdating Your System
Performing the Backdate
ISL>FASTSIZE F
If you changed the FASTSIZE value:
a. Reset the system again to set the new Fastsize value.
b. Reboot from the alternate boot path.
6. Update the system with the factory SLT.
ISL>UPDATE
7. Confirm the date and time.
8. Boot the system from the primary boot path.
1. Boot messages can vary, respond as appropriate depending on the system model.
2. Enter Y to the Interact
with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
Listing 5.0 or 5.5 System Configuration
Listing the system configuration uses the off-line diagnostic tool, Mapper. To get help using
Mapper, type help at the mapper prompt. Refer to “Listing the System Configuration” in
Chapter 5 , “Modifying Your System,” for additional information about these steps.
To list the 5.0 or 5.5 system configuration:
1. Check that all hardware peripherals are attached and powered on.
2. Start ODE.
ISL>ODE
3. Display hardware configuration.
ODE>RUN MAPPER
4. Record I/O configuration.
Note the MPE/XL Model String: value. Refer to Appendix B , “Configuration Tables,” for
the configuration group name.
5. Exit mapper.
ODE>EXIT
Start the System
When the update is complete, autoboot begins. Perform the following steps to ensure the
system is up and running. Refer to “Starting the System” in Chapter 5 , “Modifying Your
System,” for additional information about these steps.
1. Start the system.
ISL>START NORECOVERY NOSYSSTART group= configname
configname —the configuration group for your system. Refer to Appendix B ,
“Configuration Tables,” for a list of configuration groups.