HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Chapter 6 155
Finishing the Process
6.8 Restarting Selected System Functions
:NETCONTROL START;NET=ROUTER1
:NSCONTROL START
NOTE JFTPSTRT.ARPA.SYS is no longer part of the FTP product. It is no longer
necessary to stream JFTPSTRT.ARPA.SYS. For FTP to work, you DO need to
follow the instructions in Appendix A “Configuring File Transfer Protocol
FTP”.
4. Start Internet Services.
If you have any Internet Services configured (telnet, ftp, etc.), stream the Internet
Super Daemon job.
:STREAM JINETD.NET.SYS
For more information, refer to the Configuring and Managing MPE/iX Internet
Services manual.
5. Turn HP Predictive Support back on.
If you are using the HP Predictive Support software as part of your Hewlett-Packard
hardware support contract, ensure that an HP Predictive Support run completes
successfully.
a. Issue the HP Predictive Support command:
:RUN PSCONFIG.PRED.SYS
This run of HP Predictive Support may include a transfer of files to the
Hewlett-Packard Response Center. If a transfer is needed,
be sure it completes
because the system update overwrites the information in the file
PSDCFILE.PRED.SYS.
b. Select item 4, Configuration, from the Main menu.
c. Select item 5, Schedule, from the Configuration Options menu.
d. Select item 1, Schedule (ON/OFF), from the Schedule menu.
e. Set the preference, at the prompt, type ON:
Type schedule preference (on/off) or // to cancel: __
f. Exit the program, at the prompt, type EXIT:
Type an item number, an item key, or a command: __
g. Save the values, at the prompt, type YES:
Do you wish to save these values (Y/N)? __
• Restarting Selected System Functions completed. Go to the next section on
your checklist.