HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Chapter 5 139
Modifying Your System
5.17 Rerunning HP Patch/iX
HP Patch/iX (y/n)?
NOTE
This prompt is provided to allow you to continue, in the event that you halted
the HP Patch/iX process prior to completing the CSLT creation (Phase I).
If you accidentally type NO, HP Patch/iX purges all audit files and rebuilds
them. If you did not complete the CSLT/STORE or STORE only creation (Phase
I), you will have to start your patching process from the beginning. However,
if you have completed the steps and procedures correctly up to now, you can
go directly into Phase 2 of Patch/iX by typing: :PATCHIX PHASE2
10.If you are performing an Add-on (SUBSYS) task, proceed to Step 11.
If you are performing a Manage Patch task only, proceed to Step 12.
Add-on Tasks
11.Mount the SUBSYS tape when prompted, put the tape drive online, and press
[Return].
The time it takes to restore the software files varies depending on which specific
subsystems you have on your system. Watch for this message that the files are restored:
FILES RESTORED.
The SUBSYS tape has been successfully restored.
Processing STORE Files . . .
DONE
DONE
Go to Step 12.
12.Mount the CSLT tape, put the tape drive online, and reply to the prompt.
Mount the CSLT and put the tape/DDS drive ONLINE.
The HP-supported software files will be restored.
The system then restores files, processes STORE files, creates the accounting structure,
and processes installation files.
13.Follow anyadditional instructions displayed on the screen, such as mounting other tape
volumes (if using half-inch magnetic tapes).
Reply to tape requests, if necessary.
When HP Patch/iX finishes the task you specified, you will see the following message:
The installation is now complete.
Manually Installed Products
14.If you need to install any products that cannot be automatically installed, install them
now.
Refer to the list of products in Appendix A , “Manually Installed Products,” and follow
the directions for installing these products.
• Rerunning HP Patch/iX completed. Go to the next section on your checklist.