HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Chapter 5 127
Modifying Your System
5.12 Shutting Down the Remote System
5.12 Shutting Down the Remote System
To shut down the remote system:
1. Log onto the remote system console.
:HELLO MANAGER.SYS,INSTALL;HIPRI
:SPOOLER LP;START
:STREAMs
streams_device
A common
streams_device
value is 10. An LP device must be configured in SYSGEN.
Already spooled and streamed messages might display.
2. Shutdown the system.
CTRL-A
=SHUTDOWN
3. Reset the system after the last shutdown message (SHUT6).
a. If you have an HP 3000 Series 99x, connect to the service processor before you can
restart the system. Type the following:
CTRL-B
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
Do not respond to the question:
Press any key within 10 seconds to cancel boot with this
configuration.
There are 5 to 10 minutes of system activity, then the Processor Dependent Code
(PDC) screen displays.
b. For all other systems, enter the following commands to reset the system:
CTRL-B
CM>RS
If the system does not respond to the CTRL-B entry within ten seconds, press the
reset button, key switch, or on/off switch as appropriate for your system. The system
will halt, and then restart automatically.
Enter Y to confirm restarting the system.
• Shutting Down the Remote System completed. Go to the next section on
your checklist.