HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
116 Chapter5
Modifying Your System
5.7 Creating the CSLT Using AUTOINST
b. If it appears, reply to the prompt to continue processing patches.
Typing Y accepts the qualified patches. AUTOINST includes them in the CSLT, and
continues with creating the CSLT.
Typing N rejects the qualified patches, AUTOINST does not include the patches in the
CSLT, but does continue with creating the CSLT.
Do you wish to continue with installation of the patches
listed above (y/n)?
The final patch processing takes about 20–45 minutes. AUTOINST restores the patch
files and displays:
The files from the POWERPATCH tape were successfully restored.
AUTOINST processes the patch files and displays:
Processing patch files . . .Creating CSLT
c. Dismount the PowerPatch tape.
d. Proceed to Step 17.
17.Mount write-enabled tape to create the CSLT. Reply to the tape request if needed.
a. AUTOINST updates temporary copies of the system libraries then creates the CSLT.
This can take up to 2 hours.
The installer will next update staged copies of the
System SL, XL, and NL. . .
b. Monitor progress messages.
The update tool checks for disk space. If you receive an error message refer to
Appendix H , “Error Messages and Warnings,” and Appendix C , “Managing Disk
Space,” for actions.
c. AUTOINST finishes creating the CSLT and displays:
Creating the CSLT ... done
Phase I of AUTOINST is now complete. Dismount and label the CSLT
AUTOINST CSLT HPVERSION
v.uu.ff
. Ensure that the write is now
DISABLED.
18.A warning message displays and lists manually installed products it cannot install, if
applicable.
Record the product names that it cannot install on your checklist.
19.A warning message displays and lists data communications products that may require
I/O configuration, if applicable.
WARNING -- The following data communication products may
require I/O configuration changes. However, this will not
affect the software installation for these products.
(INSTWARN #3)
Record on the checklist the communication product names.
AUTOINST displays the following message that indicates that the CSLT is created: