HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Chapter 5 109
Modifying Your System
5.4 Starting the System
5.4 Starting the System
When the update is complete, autoboot begins. Perform the following steps to ensure the
system is up and running.
To start the system:
1. Start the system.
ISL>START NORECOVERY NOSYSSTART
If you are Installing a New System, add group=
configname
to the command string.
ISL>START NORECOVERY NOSYSSTART GROUP=configname
where
configname
is the configuration group for your system. Refer to Appendix B ,
“Configuration Tables,” for a list of configuration groups.
2. Confirm the date and time.
You are prompted to confirm the date and time. If the date and time displayed are not
correct, enter N, and enter the correct date and time. If you do not respond within 15
seconds, the system continues.
MPE/iX launch facility
Initialize_genesis - Version: <<870204.1552>>
TUE, APR 19, 1994, 10:20:03 AM (y/n)? Y/N
[TMUX_DAM] n n n n
Initialize genesis completed.
The system displays startup and initialization messages for 5 to 6 minutes. For
example:
Initialize genesis completed.
Create Console Messages completed.
Initialize memory manager completed.
Initialize resident kernel completed.
. . .
Protection of system files has been completed.
. . .
SESSION Scheduling Initialized
Initiate Operator Logon
JOB Scheduling Initialized
Successfully launched diagnostic monitor process.
During the startup process, the system makes several configuration checks and may
display warning messages. This is normal for system startup, and will not affect system
operation.
3. Dismount the System Load Tape (SLT).
Starting the System completed. Go to the next section on your checklist.