FCOPY Reference Manual (32212-90008)

122 AppendixA
FCOPY Messages
Error, Warning, and Status Messages
commands) and retry the operation. To copy from one file
to a smaller file, use SUBSET=.
135 Message WRITE ERROR TO TOFILE
Cause An error occurred while writing to the tofile.
Action Check the syntax of your command and retry the
operation.
136 Message READ ERROR FROM TOFILE
Cause An error occurred while reading from the tofile during a
"compare" or "verify" operation.
Action In a compare operation, retry the operation. If the error
persists, you must try to recreate the tofile. In a verify
operation, retry the operation.
137 * Message WARNING: AN UNLABELED TAPE OPERATION ENDS ON
AN
ERROR
Cause An operation involving a magnetic tape fromfile was
terminated by reading beyond the end of valid data rather
than by sensing an end-of-file mark.
Action This is not an error. You can avoid this message by
specifying FILES=
n where n is the number of files on the
tape.
138 Message TITLE OPTION: TITLE TOO LONG
Cause The title specified for the "list" function is longer than the
70 characters allowed, or it extends over more than one
line (record).
Action In a job, correct the command and resubmit the job. In a
session, reenter the command using the correct format.
139 Message DUMP OPTION: TOFILE RECSIZE NOT WITHIN LEGAL
LIMIT
Cause A file display was directed to an intermediate storage
device with an incorrect record size. That record size must
be greater than 60 bytes (30 words).
Action Change the record size of the intermediate storage file
(using the MPE PURGE and BUILD commands) so that it is
within the allowed range, and then retry the operation.