FCOPY Reference Manual (32212-90008)

Appendix A 111
FCOPY Messages
Error, Warning, and Status Messages
Error, Warning, and Status Messages
These are the messages you are likely to encounter when you use the FCOPY subsystem.
NOTE In the text,
* indicates a WARNING message
** indicates a STATUS message
Message < CONTROL Y >
Cause Acknowledges receipt of a
CTRL Y entered during a session.
Action None.
Message READ ERROR FROM COMMAND INPUTFILE
Cause An error occurred while reading an FCOPY command from $STDIN.
Action In a job, resubmit the job. In a session, reenter the command.
Message WRITE ERROR TO COMMAND LISTFILE
Cause An error occurred while writing an FCOPY message to $STDLIST.
Action It is likely that nothing serious occurred and all FCOPY operations were
performed successfully. To make sure, however, do the following:
In a job, resubmit the job. In a session, reenter the most recent FCOPY
command.
Message SYNTAX ERROR: EOF FOUND IN COMMAND FILE, MISSING
EXIT COMMAND
Cause The command input file did not contain an EXIT command.
Action Correct the input file.
3 Message SYNTAX ERROR: IN SUBSET OPTION
Cause The SUBSET function was not specified properly.
Action In a job, correct the command and resubmit the job. In a
session, reenter the command using the correct format.