DCE for the HP e3000 (B3821-90002)

Configuring DCE Cells
Using the DCE Configuration Options
Chapter 3
37
Figure 3-13 Add CDS Client
Answer “Yes” if my_machine (the name of your machine) is on the same LAN as the
remainder of the cell. If you are not sure if they are on the same LAN, respond “No.”
An incorrect “No” answer causes a local CDS cache to be set up for the client machine;
an incorrect “Yes” answer results in an incorrect network profile and a non-functional
DCE cell.
5. Respond to the “...multiple LAN's...” question as shown in Figure 3-14.
Figure 3-14 Using Multiple LANs Question
One DCE daemon job (cdsadv) is now running and you are informed that this
machine is now a CDS client.
6. If you want to continue adding your machine as a DTS client, refer to Figure 3-15 and
respond with a “Yes” to the following prompt; however, if you are not using DTS
within the cell or you want this node to be a DTS server, respond “No” to the prompt:
Figure 3-15 Continue or Exit
7. Respond “No” to the ...make this a DFS client prompt. DCE/3000 does not support DFS.
Removing or Reconfiguring a Client
The procedure described below is used for:
• removing a client
• reconfiguring a client
.
.
.
Continue or exit from dce_config. Do you wish to continue? Y
.
.
.
Enter name of primary CDS server: server1
Can my+machine broadcast to server1?
Are you using multiple LAN’s within this cell? (n): n
.
.
.
...continue or exit from dce_config. Do you wish to continue? y