DCE for the HP e3000 (B3821-90002)

Configuring DCE Cells
Using the DCE Configuration Options
Chapter 3
34
To configure a DTS server, perform the following steps:
1. Select “2. Additional Server Configuration” from the DCE Configuration Menu. The
Additional Server Configuration menu as shown in Figure 3-8 is displayed.
Figure 3-8 Additional Server Configuration
2. Select “2. DTS” to configure the DTS server. The DTS Configuration Menu as shown
in Figure 3-1 is displayed.
Figure 3-9 DTS Configuration Menu
3. Start the DTS daemon:
• For servers on the same LAN, select “1. DTS Local Server”.
• For servers that intend to communicate across LAN boundaries, select “2. DTS
Global Server”.
For a discussion about the use of DTS global servers for time servers
communicating between LANs, refer to the OSF DCE Administration Guide —
Core Components (B3190-90034).
Either selection starts the DTS daemon.
Additional Server Configuration
1. Additional CDS Server(s)
2. DTS
3. Replica Security Server
98. Return to previous menu
99. EXIT
selection:
DTS Configuration Menu
1. DTS Local Server
2. DTS Global Server (needed only in multi-LAN cells)
3. DTS Clerk (needed only when changing back to a clerk)
4. DTS Time Provider
98. Return to previous menu
99. EXIT
selection: