DCE for the HP e3000 (B3821-90002)

Chapter 3
29
3 Configuring DCE Cells
This section provides general information on using the DCE configurator to add your
MPE/iX HP 3000 system into a cell. It is divided into two subsections:
• Using the DCE Configuration Tool — provides detailed steps to bring up the DCE
Configuration main menu (these steps must be completed each time you change the
DCE cell configuration).
• Using the DCE Configuration Options — provides detailed steps for each option in
the DCE configuration main menu (basic familiarity with DCE terms and concepts
are assumed, as described in the Introduction to OSF DCE (B3190-90005).
NOTE To configure a cell, you must have previously completed the installation procedure (refer
to Chapter 2, “Installing DCE/3000 Software,” for planning and installation
information).