DCE for the HP e3000 (B3821-90002)

Installing DCE/3000 Software
Installation
Chapter 2
28
Installation
To install DCE/3000, perform the following steps:
1. Log off all users and log on at the console as MANAGER.SYS.
2. Create the following groups if they do not exist. At the system prompt, enter:
NEWGROUP HPDCE.SYS
NEWGROUP THREADS.SYS
NEWGROUP B3821A.SUPPORT for product B3821AA
or
NEWGROUP B3822A.SUPPORT for product B3822AA
3. Restore the files from your DCE product tape.
NOTE Do not use the local option in the RESTORE command. If the local option is used, the DCE
files will not be restored correctly.
At the system prompt, enter:
FILE TAPE;DEV=TAPE
RESTORE *TAPE;@.@.@;SHOW
4. Start the product installation job by entering the following:
STREAM I00B3821.B3821A.SUPPORT for product B3821AA
or
STREAM I00B3822.B3822A.SUPPORT for product B3822AA
5. If the message “DCE has been successfully installed” is displayed at the console, the
DCE installation has completed successfully.
If the message is not displayed or if a warning message(s) is display at the console,
the DCE software has probably not completed its installation. Check the spoolfile to
find out why it will not complete.
NOTE If you currently have DCE configured but stopped, then the /etc/rc.dce file contains the
current configuration. The installation job (IOUB3821 or IOUB3822) will not write
over this file, instead it renames the new /etc/rc.dce file to /etc/rc.dce.102. It is
strongly recommended that you compare your /etc/rc.dce file with the /etc/rc.dce102
file and make any necessary changes.
6. Ensure that the network services are brought up with the appropriate interface
name. You must install the DCE software on all of the HP 3000 systems that you plan
to configure in your cell. After all of the systems have DCE/3000 installed, you can
configure your cell.
Refer to Chapter 3, “Configuring DCE Cells,” for cell configuration information.