Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

78 Chapter5

Conﬁguring Serial Devices (for Host-Based Management)

Modify the Network Management Conﬁguration File

3. In the ﬁeld after the question, “Do you have X.25

system-to-system or PAD connections?”, enter an N for no.

If you have X.25, refer to the Conﬁguring and Managing Host-Based

X.25 Links manual.

4. After you enter the information on the screen, press the [Save Data]

function key to save your entries.

5. After the data is saved (the Data ﬂag in the upper right-hand corner

is Y), press the [DTS] function key.

Step 4: Conﬁgure the Link

The Host Conﬁguration screen is displayed when you press the [DTS]

function key at the Main screen (Figure 5-3).

This screen is used to conﬁgure the Datacommunications and Terminal

Subsystem (DTS) on the HP 3000. DTS deﬁnes the interaction between

the system and any asynchronous devices, such as terminals and

printers.

Figure 5-3 Host Conﬁguration Screen (Host-Based)

1. “Local HP 3000 node name” is a display-only ﬁeld. Verify that it

is correct.

2. The “Link name” ﬁeld displays DTSLINK. This is used by the

HP 3000 DTS subsystem. Use this default.