Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 5 71
Configuring Serial Devices (for Host-Based Management)
5 Configuring Serial Devices (for
Host-Based Management)
This chapter provides step-by-step instructions for configuring
terminal, printer, and other serial device connections on the HP 3000
Series 900 using host-based management (that is, when the DTCs are
managed by the HP 3000 host). For information on configuring for
PC-based management, refer to Chapter 6, “Configuring Serial Devices
(for PC-Based Management).” PC-Based Management means that you
use an HP OpenView Workstation (PC) to manage your DTCs.
This chapter will use the configuration information that was collected
on the worksheets in Chapter 2, “Before Configuring Terminal and
Printer Connections.”
NOTE If you use OpenView DTC Manager to manage your DTCs, refer to
Chapter 6, “Configuring Serial Devices (for PC-Based Management),”
instead of this chapter.
This chapter contains configuration information for host-based
management (that is, when the DTCs are managed by the HP 3000
host).
NOTE If you are configuring X.25 networking capabilities on a HP 3000
Series 900 computer using host-based network management, use
Configuring and Managing Host-Based X.25 Links instead of this
manual to configure DTCs and DTC connections.