Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 4 69

Dynamic Conﬁguration and DTS Shutdown/Restart

DTS Restart

The DTS restart capability is provided by the DTCCNTRL command and

allows you to restart the DTS subsystem.

NOTE

The DTS must ﬁrst be shut down before it can be restarted.

Performing a DTS Restart

To perform a DTS restart, type the DTCCNTRL command at the CI

prompt either without specifying the desired restart operation or by

specifying it using the syntax outlined below:

• DTS restart operation not speciﬁed:

• DTS restart operation speciﬁed:

:DTCCNTRL func=restart

NOTE

To dynamically conﬁgure DTS changes, refer to the “Dynamic

Conﬁguration” section earlier in this chapter. To automatically

add/conﬁgure a host-based managed DTC to DTS without needing to

specify detailed conﬁguration information such as DTC cards/boards

and ldevs, refer to Chapter 3, “Automatic Conﬁguration of DTCs.” To

manage/dynamically conﬁgure host-based X.25 links, refer to the

Conﬁguring and Managing Host-Based X.25 Links manual.

:DTCCNTRL

0 exit

1 dynamically implement DTS changes made in NMMGR

2 view status of last DTS dynamic configuration

3 automatically add a new DTC

4 shutdown DTS subsystem

5 restart DTS subsystem

6 manage/dynamically configure host-based x.25

7 help

For help on these topics, select 7 at the prompt below.

Select one of the numbers above corresponding to the

desired operation: 5