Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 4 57
Dynamic Configuration and DTS Shutdown/Restart
Dynamic Configuration
Table 4-1 Dynamically Configurable Tasks
Task
Action Required for Change to Become
Active
Add/configure new terminal/printer No action; changes take effect dynamically
Add/delete class name
Change DTC event logging class
Host-based X.25 configuration changes:
– maximum number of PAD connections
– X.25 link name
– maximum number of switched virtual circuits
– remote X.25 addresses and security
– X.25 allow access
– remote X.25 calling address
– PAD password
Change SNMP filter
Change NLIO from N to Y in terminal profile
Increase number of non-nailed TIO/PAD ports
Change terminal to printer or vice versa* Logoff any sessions or close any jobs
associated with changed devices. If device is a
printer, stop the spooler.
Change device profile characteristics:
– change line speed
– change term type file name/number * For these changes, the device must not be
owned when dynamic configuration is
invoked. The terminals must be logged off and
the printers must be not spooled.
– change modem type
– change speed/parity
– change hardware handshaking
– change reset HP terminal
– change allow :HELLO logon
– change record width
Delete:
– terminal/printer*
– ldev*
– DTC*
Decrease number of non-nailed TIO/PAD ports*
Change starting ldev of non-nailed ports*