Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

232 AppendixD
Error Messages
Validation Error Messages
Path: NMMGRpath — Too few non-nailed ldevs available above TIO
start ldev. (DTSERR=89)
(DTSERR 89) Cause: There are not enough ldevs available above the TIO start ldev
number to configure the number of ldev specified.
Action: Lower the number of TIO non-nailed ldevs or delete all TIO
non-nailed ldevs and specify a lower starting ldev number. Then add
the desired number of ldevs.
Path: NMMGRpath — Too few non-nailed ldevs available above PAD
start ldev. (DTSERR=90)
(DTSERR 90) Cause: There are not enough ldevs available above the PAD start ldev
number to configure the number of ldev specified.
Action: Lower the number of PAD non-nailed ldevs or delete all PAD
non-nailed ldevs and specify a lower starting ldev number. Then add
the desired number of ldevs.
Path: NMMGRpath — Attached device for LDEV #nnn, defined in
Profile <profname>, is not supported on DTC16 and DTC48.
(DTSERR=92)
(DTSERR 92) Cause: Modem devices configured (either US inout modem or
European inout modem) are not supported on DTC16 or DTC48.
Action: Go to DTC specified in NMMGRpath and change the modem
type to required modem type other than US inout or European inout.
Path: NMMGRpath — Eight bit with parity for LDEV #nnn, defined in
Profile <profname>, is not supported on DTC16 and DTC48.
(DTSERR=93)
(DTSERR 93) Cause: Eight bit data length with odd/even parity (“8odd” or
“8eve”) feature is not supported on DTC16 or DTC48.
Action: Go to DTC specified in NMMGRpath and change the entry for
the parity to the required value other than “8eve” or “8odd”.
Path: NMMGRpath — Two stop bits for LDEV #nnn, defined in Profile
<profname>, is not supported on DTC16 and DTC48. (DTSERR=94)
(DTSERR 94) Cause: Two stops bits feature is not supported on DTC16 or DTC48.
Action: Go to DTC specified in NMMGRpath and change the entry for
the number of stop bits to one.
Path: NMMGRpath — Binary port config for LDEV #nnn, defined in
Profile <profname>, is not supported on DTC16 and DTC48.
(DTSERR=95)
(DTSERR 95) Cause: The feature for forcing data length and parity when binary
mode is selected is not supported on DTC16 or DTC48.
Action: Go to DTC specified in NMMGRpath and change the entry for
the binary port config field to “N”.