Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

17
Chapter 5, “Configuring Serial Devices (for Host-Based Management),
and Chapter 6, “Configuring Serial Devices (for PC-Based
Management).”.
1. Run NMMGR.PUB.SYS.
2. Modify your existing DTS configuration as necessary.
3. Validate your network configuration. (SYSGEN cross-validation is
done automatically within NMMGR.)
4. At the prompt seen after cross-validation is complete, select to have
DTS changes take effect dynamically.
5. Exit NMMGR.
6. Complete any additional actions as appropriate (such as rebooting
the DTC) for changes to become active.
Automatic
Configuration
If you are using host-based management to manage your DTCs, you can
also add and configure a new DTC automatically without needing to
specify detailed configuration information such as DTC cards/boards
and ldevs. This can be done either within the NMMGR utility or
without running NMMGR. Refer to Chapter 3, “Automatic
Configuration of DTCs.
NOTE
If you are using the HP OpenView DTC Manager on the PC to manage
the DTCs, you must also configure the OpenView DTC Manager. For
more information, refer to Using HP OpenView DTC Manager.