Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

168 Chapter8
Additional DTC Configuration
Configuring SNMP
Figure 8-5 SNMP MIB Configuration Screen
The “DTC Name” field is a read-only field which indicates the SNMP
configuration is for that specific DTC.
1. The “SysContact”, “SysName”, and “SysLocation” fields
provide optional information about the DTC such as contact person,
the DTC’s fully-qualified name and physical location.
Each field allows text up to 256 alphanumeric characters and is case
sensitive.
2. The “Enable authentication traps” field indicates whether
the SNMP agent should generate authentication failure traps. Enter
Y to enable trap generation (see the section on “Configuring Trap
Destinations”); enter N to disable it.
3. After you have configured the MIB parameters, press the
[Save Data]
function key.
4. Press the
[Go To Trap] key to configure trap destinations or the
[Go To Filter] key to configure authorization filters. Or, if you have
completed configuration for your DTCs, press
[Validate DTS/LINK] to
validate your configuration.