Communicator e3000 MPE/iX Release 6.5 (Non-Platform Software Release C.65.00 (30216-90291)
122 Chapter4
Data Center Management
SureStore E Disk Array XP256 Business Copy XP and/or Continuous Access XP in an HP 3000 Environment
(MPE/iX Prompt):dstat all
LDEV-TYPE STATUS VOLUME (VOLUME SET - GEN)
---------- -------- --------------------------
60-OPEN-3 MASTER MEMBER1 (PRODUCTION_DATA-0)
61-OPEN-3 MEMBER MEMBER2 (PRODUCTION_DATA-0)
62-OPEN-3 MEMBER MEMBER3 (PRODUCTION_DATA-0)
4. Next, create the directory and accounting structure on the system that will use the
User Volume. Be sure to remember to use the proper syntax and parameters
ONVS
and
HOMEVS
when creating the groups. You are now ready to restore or create the files that
will reside on the user volume set PRODUCTION_DATA.
From the Remote Control PC, configure the LUNs and paths for the Business Copy
volumes and start the copy operation. This takes about 1 GB per minute depending on
your configuration. Once this operation has completed, you may proceed.
At this point you should have a system configured with a user volume set name
PRODUCTION_DATA and a directory and accounting structure that is accessible from
System B. You should also have a copy of this volume set maintained by Business Copy.
To access the files and directories when this volume set is “moved” over to System B,
you need to have the identical directory and accounting structure on System B that is
already on System A.
BULDACCT To access those files on the Business Copy volumes you must first create
the accounts and groups on System B, that reference the directory
structure located on the user volume. Re-issue the NEWACCT and
NEWGROUP commands on System B or use BULDACCT to create a job
stream that will create the directory for you.
5. Execute the buldacct utility program and for this example three accounts exist on the
PRODUCTION_DATA volume set. SALESDB, ORDERDB and STOCKDB.
:RUN BULDACCT.PUB.SYS;INFO=”SALESDB,ORDERDB,STOCKDB%VSACCT=PRODUCTION_DATA”
This will create 2 files BULDJOB1 and BULDJOB2. These files create the directory
structure and re-create the UDC linkages. Store these files off and restore them to
System B. (DSCOPY can also be used)
System B Procedures
1. Either re-issue the NEWACCT commands that pertain to creating the accounts on the
system volume set and only those NEWGROUP commands that you used the parameter
HOMEVS or restore the BULDJOB1 and BULDJOB2 files onto System B and stream those
jobs.
2. From Sysgen or IOCONFIG issue the commands to configure the LDEVs of the Business
Copy volumes. Be sure that the copy has completed.
If you used Sysgen to configure the volumes you will need to reboot the system. If
IOCONFIG was used, then it will try to mount the volumes as you add the LDEVs.
Once the volumes are configured and the directory structures are intact, issue the
dstat all command.
(MPE/iX Prompt):dstat all
LDEV-TYPE STATUS VOLUME (VOLUME SET - GEN)