Communicator e3000 MPE/iX Release 6.5 (Non-Platform Software Release C.65.00 (30216-90291)

Chapter 4 121
Data Center Management
SureStore E Disk Array XP256 Business Copy XP and/or Continuous Access XP in an HP 3000 Environment
Figure 4-1. Basic Setup of Business Copy
System A Procedures
Setup System A
The first time setup requirements are as follows:
1. Create the Logical Unit Numbers (LUNs) and paths you will use on the XP256 and then
using Sysgen or IOCONFIG create the LDEVs associated with the paths and LUNs.
Make sure to use HPDARRAY as the ID type. We use the LDEV 60 through 62 for our
examples.
Test that MPE/iX recognizes the new LDEVs by either rebooting and running ODE
Mapper or if you used IOCONFIG to issue the commands, use DSTAT ALL.
(MPE/iX Prompt):dstat all
LDEV-TYPE STATUS VOLUME (VOLUME SET - GEN)
---------- -------- --------------------------
60-OPEN-3 UNKNOWN
61-OPEN-3 UNKNOWN
62-OPEN-3 UNKNOWN
(MPE/iX Prompt):
2. Now create the User Volume Set that will be used to off-load processing. The volume set
name for this example is PRODUCTION_DATA. Use the VOLUTIL utility program to
create the user volume set named PRODUCTION_DATA. Once the volume set is created,
VSCLOSE and then VSOPEN the volume set before proceeding onward.
3. Issue the DSTAT ALL command and the following should appear: