Manualshelf

HP Smart Array Cluster Storage System

ManualsBrandsHP ManualsStorageModular Smart Array 500 Starter Kit
919293949596979899100
Cluster Installation and Configuration
5-14 HP Smart Array Cluster Storage System User Guide
HP CONFIDENTIAL
Writer: Rob Weaver File Name: f-ch5 Cluster Installation and Configuration
Codename: Aurora Part Number: 240333-003 Last Saved On: 11/6/02 1:05 PM
2. Power up one of the servers.
IMPORTANT: Do not use the Option ROM Configuration for Arrays (ORCA) utility to
configure the Smart Array Cluster Storage system at this time. When directed, use ACU to
configure the system.
While the server boots, the ROM-Based Setup Utility (RBSU) and the ORCA
utility are automatically configured to prepare the server for the operating system
installation.
— To manually configure these utilities, go to step 3.
— To use the automatically configured settings, go to step 5.
For more information about automatic configuration, refer to the ROM-Based
Setup Utility User Guide located with the server documentation.
3. When prompted during controller initialization, press the F8 key to enter ORCA
and configure the array controller.
4. When prompted during the boot process, press the F9 key to change the server
settings, such as the settings for language and operating system, using RBSU.
The system is set up by default for the English language and a Microsoft
Windows 2000 installation. Select Novell NetWare 5.x/6 as the operating
system.
5. Insert the SmartStart CD into the CD-ROM drive and reboot the server. Follow
the on-screen instructions to install the operating system.
IMPORTANT: Using the information gathered earlier, configure the TCP/IP settings for
the public and private network adapters during the operating system installation.
For more information on installing the operating system, refer to the SmartStart
installation poster included in the ProLiant Essentials Foundation Pack, or refer
to the operating system documentation
6. After the operating system installation is complete, install NetWare 5.1 Support
Pack 5 or later:
a. Insert the Support Pack CD and mount it.
b. From the system console, type
NWCONFIG